Sikalastic® TC 297 FS

• CSA S413
• ASTM C957

 Methyl methacrylate (MMA) technology

2 years

Store in unopened containers in a cool, clean, dry area

Elongation

System Adhesion

20 mil w.f.t

Between -1 °C and +32 °C (30 °F and 90 °F)

Substrate temperature must be at least 3 °C (5.5 °F) above measured dew point temperature.

Between -1 °C and +32 °C (30 °F and 90 °F)

Approx. 1.96 m²/L (80 ft²/US gal.) at 20 mil w.f.t

Colour

Sikalastic® TC 297 FS: Mix 3 oz of Sikafloor® PGM 155 pigment for every one (1) gallon of resin

Mixing

Sikalastic® TC 297 FS: Measure 1 gallon of resin and 3 oz of PGM 155 pigment into a 5-gallon pail. Mix for 2–3 minutes. Add the proper amount of powder hardener and mix for an additional 1–2 minutes. See the mixing chart below.

Required amount of Sikalastic®-918 FS (in volume ounces) for one-gallon resin, based on temperature

Required amount of Sikalastic®-918 FS (in grams) for one-litre resin, based on temperature

Note: After mixing, apply immediately. You will have 7–15 minutes of working time, dependent on temperature.

Heavy-duty Traffic System

Apply the properly mixed Sikalastic® TC 297 FS at 1.96 m²/L (80 ft²/US gal), rolling on at a 20 mil thickness. Immediately broadcast 16–30 mesh, rounded quartz sand into the wet coating to refusal at the rate of 1.0–1.5 kg/m² (20–30 lb per 100 ft²). Immediately after the aggregate is broadcast and while the coating is still wet, blow any excess aggregate using a portable blower forward into the wet coating.

Extra Heavy-duty Traffic System

Apply the properly mixed Sikalastic® TC 297 FS at 0.98 m²/L (40 ft²/US gal), rolling on at a 40 mil thickness. Immediately broadcast 16–30 mesh, rounded quartz sand into the wet coating to refusal at the rate of 1.0–1.5 kg/m² (20–30 lb per 100 ft²). After the aggregate is broadcast and while the coating is still wet, blow any excess aggregate using a portable blower forward into the wet coating.

Mock-up

Provide mock-up of at least 9.3 m² (100 ft²) to include surface profile, sealant joint, crack, flashing, and juncture details and allow for evaluation of slip resistance and appearance. Install mock-up with specified coating types and with other components noted and locate where directed by architect. Mockup may remain as part of the work if acceptable to the architect.

All components of the Sikalastic® Traffic 2900 system fully cure within one hour when properly installed. Extend the curing time in cool-weather conditions.

Clean tools with Sikafloor®-100 CLN Pronto, an MMA solvent. Other solvents such as xylene or acetone may also be used. Collect and dispose of all site waste.