Sikalastic® TC 299 FS

• CSA S413
• ASTM C957

2 years

Store in unopened containers in a cool, clean, dry area.

Taber Abrasion Resistance

Elongation

20 mil w.f.t.

Between -1 °C and 32 °C (30 °F and 90 °F)

Substrate temperature must be at least 3 °C (5.5 °F) above measured dew point temperature.

Between -1 °C and 32 °C (30 °F and 90 °F)

Approx. 1.96 m²/L (80 ft²/US gal) at 20 mil w.f.t.

Colour

• Sikalastic® TC 299 FS: Mix 6 oz of Sikafloor® PGM 155 pigment for every 3.78 L (1 US gal) of resin

Mixing

• Sikalastic® TC 299 FS: Measure 3.78 L (1 US gal.) of resin and 6 oz of pigment into a 22.7 L (5 US gal) pail. Mix for 2-3 minutes. Add the proper amount of powder hardener and mix for an additional 1-2 minutes. Refer to the mixing chart below.

Required amount of Sikalastic®-918 FS (in volume ounces) for one gallon of resin, based on temperature:

Required amount of Sikalastic®-918 FS (in grams) for one litre of resin, based on temperature:

Note: Apply the material immediately after mixing. You will have 7 – 15 minutes of working time, depending on temperature.

Heavy-duty Traffic System

1. Apply the properly mixed Sikalastic® TC 299 FS at 1.96 m²/L (80 ft²/US gal), rolling on at a 20 mil thickness using a squeegee.
2. All components of the Sikalastic® Traffic 2900 system fully cure in approximately one (1) hour when properly installed.

Extra Heavy-duty Traffic System

1. Apply the properly mixed Sikalastic® TC 299 FS at 1.96 m²/L (80 ft²/US gal), rolling on at a 20 mil thickness using a squeegee.
2. Immediately broadcast 16–30 mesh, rounded quartz sand into the wet coating to refusal at the rate of 1.0–1.5 kg/m² (20–30 lb per 100 ft²). After the aggregate is broadcast and while the coating is still wet, blow any excess aggregate using a portable blower forward into the wet coating.
3. Apply the properly mixed Sikalastic® TC 299 FS at 1.96 m²/L (80 ft²/US gal), rolling on at a 20 mil thickness using a squeegee.
4. All components of the Sikalastic® Traffic 2900 system fully cure in approximately one (1) hour when properly installed.

Mock-up 

1. Provide a mock-up of at least 9.3 m²/L (100 ft² /US gal) to include surface profile, sealant joint, crack, flashing, and juncture details and allow for evaluation of slip resistance and appearance.
2. Execute the mock-up with specified coating types and with other components noted.
3. Locate where directed by architect.
4. Mock-up may remain as part of the work if acceptable to the architect.

All components of the Sikalastic® Traffic 2900 system fully cure within one (1) hour when properly installed. The curing time will be extended in cool-weather conditions.

Clean tools with Sikafloor®-100 CLN Pronto, an MMA solvent. Other solvents such as xylene or acetone may also be used. Collect and dispose properly of all site waste.