Sika Boom®-130 FB
Sika Boom®-130 FB is a one-component, moisture-curing, low-expansion, polyurethane fire-resistant foam featuring a fire resistance up to 217 minutes.
- Fire resistance up to 217 minutes (EN 1366-4)
- Efficient seal against smoke and gas
- Does not contain CFC’s and H-CFC’s
- Low expansion polyurethane insulating foam sealant fills, seals and insulates gaps up to 25 mm (1 in)
- Excellent filling capacity
- High yield
- High thermal & acoustical insulation values
- Foam may be painted, cut, trimmed after cure
- Mould and water resistant
Usage
All applications where fire-retardant properties are required such as:
- Filling and sealing gaps, joints and cavities
- Sealing around service penetrations, electrical outlets, plumbing elements, etc.
- Sealing around penetrations through floors and runs through stud walls
- Sealing around pipes and ducts penetrations through floors and walls
Advantages
- Fire resistance up to 217 minutes (EN 1366-4)
- Efficient seal against smoke and gas
- Does not contain CFC’s and H-CFC’s
- Low expansion polyurethane insulating foam sealant fills, seals and insulates gaps up to 25 mm (1 in)
- Excellent filling capacity
- High yield
- High thermal & acoustical insulation values
- Foam may be painted, cut, trimmed after cure
- Mould and water resistant
Packaging
Net weight: 455 g/16 oz - Gross weight: 570 g/20 oz can / 12 cans per case
Colour
Orange
FAQ
For best results, the cured foam may be painted or coated for outdoor applications.
For best results, the cured foam may be painted or coated for outdoor applications.
Approx. 25 L - Depending on temperature and humidity.
Sika Boom®-130 FB is a one component, moisture-curing, low-expansion, polyurethane fire-resistant foam featuring a fire resistance up to 217 minutes.
Turn the can upside-down and screw the straw adapter firmly into place without pressing the valve. Shake the Sika Boom®- 130 FB can well for about 60 seconds before use. The output of the foam can be regulated by applying more or less pressure on the valve/adapter. For better results, the temperature of the can and the room temperature should be between +20 °C and +25 °C.
Note: Sika Boom®-130 FB can only be used in the upside-down position; failure to invert the can will prevent the foam from dispensing properly.
Fill holes and cavities to approximately 30 % of their volume to provide room for foam expansion. All building elements must be temporarily fixed until the foam has fully cured.
The Product will not adhere to surfaces such as polyethylene, Teflon, silicone, and surfaces contaminated with oils, greases, mould-release agents, and other similar materials.
Low expansion polyurethane insulating foam sealant fills, seals and insulates gaps up to 25 mm (1 in).
Does not contain CFCs and H-CFCs.
Cure Time: 24 hours
Application Temperature: +5 °C to +30 °C