Product Data Sheet Show all documents

Sika® Reemat Premium

RANDOMLY ORIENTED GLASS FIBER REINFORCEMENT FOR SIKALASTIC® ROOFPRO SYSTEMS

Surface treated, randomly oriented glass fiber reinforcement to enhance the strength and durability of Sikalastic® RoofPro 621 TC, 624 WP, and 641 Lo-VOC roofing membranes.

  • Provides maximum conformability to uneven substrates.
  • Creates strong reinforced roofing membranes with enhanced tensile strength.
  • Increases puncture and tear resistance.
Product Data Sheet Show all documents

Usage

  • Ideal for roofing applications displaying complex details and geometry or when accessibility is limited.
  • Suitable for applications where visibility of reinforcement overlaps is an aesthetic concern.
 

Advantages

  • Provides maximum conformability to uneven substrates.
  • Creates strong reinforced roofing membranes with enhanced tensile strength.
  • Increases puncture and tear resistance.

Packaging

  • 1.3 m (49") w x 90 m (295") l individually bagged rolls

  • 0.3 m (12") w x 90 m (295") l individually bagged rolls

Colour

Off-White

Product Details

Product Information

Shelf Life

Indefinite

Storage Conditions

Store flat and wrinkle-free in original, unopened and undamaged sealed packaging in dry conditions.

Store rolls on end, and not on their side.

Recommended to condition material to 10°-25°C (50°-77°F) before using to match liquid resin.

Dimensions

Gross Area:

109.6 m2 (1,180 ft2)
27 m2 (295 ft2)

Length

90 m (295")

 

Width

1.3 m (49'')

0.3 m (12'')

Mass per unit area

225 +/- 25 g/m2 (6.6 +/- 0.7 oz./yd2)

Application

Application steps

SUBSTRATE PREPARATION

Substrate surfaces, including flashing substrates, shall be primed, clean and dry, in accordance with separate System Data Sheet.

 

APPLICATION

Apply the specified base layer resin quantity to primed substrate surface with a 12.7 mm (1/2”) nap phenolic resin core roller. Immediately place Sika® Reemat Premium into wet resin, overlapping reinforcement 50.8 mm (2”) along the sides and at the roll ends. Apply wet roller to topside with light pressure to completely saturate the Reemat and to allow the Reemat to conform to substrate irregularities and flashing conditions. Apply additional resin as required to top of the Reemat to aid in conformity.

Documents