Product Data Sheet Show all documents

KING 2-1-9 Coloured

KING coloured Type N and Type S mortars are pre-mixed, pre-bagged, and specially designed for use when laying bricks, natural stones, concrete blocks and other masonry products. These mortars are generally composed of, but not limited to containing, Type GU Portland Cement, hydrated lime, an air-entraining agent, masonry sand with controlled grain size, and an Iron Oxide, a Carbon Oxide or pigment from other sources.

  • Factory calibrated mix
  • Superior adhesion
  • Increases waterproofing capacity of the masonry wall
  • Good resistance to freeze-thaw cycles
Product Data Sheet Show all documents

Usage

  • Laying clay brick, natural stone or concrete blocks
  • Indoors, outdoors or for any other masonry application where high bond strength is required
  • Parging

Advantages

  • Factory calibrated mix
  • Superior adhesion
  • Increases waterproofing capacity of the masonry wall
  • Good resistance to freeze-thaw cycles

Packaging

This product is packaged in 30 KG (66 lb), triple-lined bags or bulk bags, wrapped on wooden pallets.

Colour

coloured 

Documents

Sustainability Documents

EPD for Masonry Mortars and Grouts
EPD for Masonry Mortars and Grouts
Environmental Product Declaration (EPD)
PDF - 1 MB (en)

Calculator

masonry-mortar-calculator
Quantity Estimator
Calculate how much grout or mortar you require.

Related Pages

Brick or Stone Concrete

Concrete brick units often have a low absorption rate. Therefore in order to reflect this characteristic, it is not uncommon for the mason to adjust the required amount of water.

Granite Stone Facing

Installation of any exterior facing is particularly important, since the facing is the first defence against water infiltration. One of the roles of mortar is to effectively manage rainwater flowing over the facing.

Concrete Blocks Indoor

The type of mortar to be used for installing concrete blocks indoors depends on the type of application. Since there will be no rainwater to manage, lime mortars are not necessary.

Exterior Chimney

The elements that make up an exterior chimney are subject to a high level of saturation. Furthermore, installation of any exterior facing is particularly important, since the facing is the first defence against water infiltration.

Concrete Block Foundation

Concrete block elements, which make up a buried foundation wall, are generally exposed to a high level of saturation. For this type of application, standard CSA A 179-14 recommends using a Type S Mortar, at a minimum.

Natural Stone Foundations

The natural stone elements that make up a buried foundation wall are generally exposed to a high level of saturation. For this type of application, standard CSA A 179-14 recommends using a Type S Mortar, at a minimum.

Parapet

Elements that compose an outdoor parapet are subject to a high level of saturation since the front, back and top are exposed to the elements.

Construction of a Retaining Wall

Since it takes less energy to manufacture lime than Portland Cement, it is always preferred from an environmental standpoint to use a lime mortar.

Retaining Walls

In addition to usually being exposed to de-icing salts, retaining walls, just like chimneys and parapets, are often exposed to elements such as wind and rain. Furthermore, they are exposed to a large number for freeze-thaw cycles without much protection.

Walls Built From 1975 to Today

Walls built between 1975 and today are generally constructed from a steel or wooden structure to which a masonry facade is attached. These walls are often built using a mortar containing masonry cement or a pure lime and Portland cement based mortar.

Rejointement des escaliers

Afin de vous aider avec ce type de travaux, il n’est pas inopportun de se tourner vers un matériau plus moderne, tel le polyuréthane. Les mortiers fabriqués à partir de polyuréthane -deux composantes- offrent une grande adhérence au support,