Sikafloor® UTE Colour Pak
Sikafloor® UTE Colour Pak is a premeasured, concentrated epoxy pigment specifically formulated for adding colour to Sikafloor® 219 UTE universal epoxy resin system.
- High solids content, low odour formulation.
- Reduces inventory requirements.
- Excellent opacity at recommended dosage rates.
- Excellent dispersion properties during mixing.
Usage
Sikafloor® UTE Colour Pak may only be used by experienced professionals. Sikafloor® UTE Colour Pak is used in conjunction with Sikafloor® 219 UTE epoxy resin system to produce a solid colour, concrete primer, broadcast surfacing or trowel mortar binder, and high-build coating.Advantages
- High solids content, low odour formulation.
- Reduces inventory requirements.
- Excellent opacity at recommended dosage rates.
- Excellent dispersion properties during mixing.
Packaging
Packaged in 500 ml (16.9 oz) plastic jars.
Six (6) Sikafloor® UTE Colour Pak jars per carton.
Colour
Refer to the Sikafloor® UTE Colour Pak Colour Chart.
Product Details
APPROVALS / CERTIFICATES
- Meets the requirements of CFIA and UDSA for use in food plants.
Shelf Life
12 months in original unopened container under proper storage conditions.
Storage Conditions
Store dry between 5 °C to 32 °C (41 °F to 89 °F).
Condition product at temperatures between 18 °C to 24 °C (65 °F to 75 °F) befiore using.
Application
Consumption
Add 1 x 500 ml (16.9 oz) Sikafloor® UTE Colour Pak for every 3.78 (1 US gal.) of Part A of Sikafloor® 219 UTE resin.
NOTE: When using bright colours, additional coats may be required to achieve opacity. Using more Sikafloor® UTE Colour Pak pigment than recommended will result in extended cure times and reduced chemical and abrasion resistance.
MIXING
Premix each component seperately, including the Sikafloor® UTE Colour Pak to ensure product uniformity. For all colours, add one (1) 500 ml (16.9 oz) Sikafloor® UTE Colour Pak for every 3.78 L (1 US gal.) of Component A resin and mix at low speed (300 - 450 rpm) for three (3) minutes until a uniform colour is achieved using a drill fitted with an Exomixer® or Jiffy type paddle. Be careful not to introduce any air bubbles during the mixing process.
Empty Component B (Hardener) in the correct mix ratio to Component A (Resin) and mix for additional three (3) minutes. Be careful not to introduce any air bubbles while mixing. Make sure the contents are completely mixed to avoid any weak or partially cured spots in the coating. During the mixing operation, scrape down the sides and bottom of the container with a flat or straight edge trowel at least once to ensure complete mixing.
NOTE: When using bright colours, additional coats may be required to achieve opacity. Using more Sikafloor® UTE Colour Pak pigment than recommended will result in extended cure times and reduced chemical and abrasion resistance.
APPLICATION
Please refer to the most current version of the local Sikafloor® 219 UTE product data sheet for Substrate Preparation, Mixing, and Application Instructions.
